TRENDnet Computer Drive TEW 424UB User Manual

Quick Installation Guide  
TEW-424UB  
 
1. Before You Start  
Package Contents  
TEW-424UB  
Utility & Driver CD-ROM  
Quick Installation Guide  
USB Cable  
System Requirements  
USB port: 1.1 or 2.0  
CD-ROM Drive  
CPU: Intel Pentium 300MHz or above  
Memory: 256MB RAM or above  
Windows XP/2000/ME/98SE  
Application  
Workstation with 54Mbps  
Wireless USB 2.0 Adapter  
(TEW-424UB)  
Cable/  
DSL Modem  
54Mbps 802.11g  
Wireless Firewall Router  
(TEW-432BRP)  
Workstation with 54Mbps  
Wireless PCI Adapter  
(TEW-423PI)  
Notebook with 54Mbps  
Wireless PC Card  
(TEW-421PC)  
1
 
English  
2. How to Install  
Important! DO NOT install the USB adapter in the computer until instructed to  
do so.  
Note: Refer to the User's Guide on the Driver CD-ROM for Windows 98SE and  
Windows ME installation instructions  
1. Insert the Utility & Driver CD-  
ROM into your computer's  
CD-ROM Drive and then click  
Install Utility.  
2. Follow the InstallShield Wizard  
instructions.  
Windows 2000  
Windows XP  
3. Click Yes.  
3. Click Continue  
Anyway.  
2
 
English  
4. Click Finish.  
5. Connect the wireless adapter to an  
available USB port on your  
computer.  
Windows 2000  
Windows XP  
6. Drivers will install  
automatically.  
6. Select No, not this  
time, and then click  
Next.  
3
 
English  
Windows 2000  
Windows XP  
7. Click Install the  
software  
automatically  
(Recommended)  
and then click Next.  
8. Follow the Found New  
Hardware Wizard  
instructions.  
7. Click Yes. Then,  
Continue to Step 10  
9. Click Continue  
Anyway.  
4
 
English  
10. Select the appropriate country  
domain and then click OK.  
11. Click Yes.  
12. Click Finish.  
Your installation is now complete.  
For detailed information regarding the TEW-424UB configuration and advanced  
settings, please refer to the User's Guide included on the Utility & Driver  
5
 
English  
3. Wireless Configuration  
Note: If you are running Windows XP, you need to disable Wireless Zero  
Configuration. Please refer to question 4 of the Troubleshooting section.  
1. On the bottom right-hand corner of  
the screen, double-click on the  
wireless LAN Configuration  
utility icon  
2. Click Site Survey.  
3. Click the SSID that matches your  
wireless access point and then  
click Connect.  
Wireless configuration is now complete.  
For detailed information regarding the TEW-424UB configuration and advanced  
settings, please refer to the User's Guide included on the Utility & Driver CD-  
6
 
English  
Troubleshooting  
Q1: I inserted the Utility & Driver CD-ROM into my computer's CD-ROM Drive but the installation menu  
does not appear automatically. What should I do?  
A1: If the window does not appear automatically, click Start, click Run, and type D:\autorun.exe where "D"  
in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your  
keyboard.  
Q2: I completed all the steps in the quick installation guide, but my Wireless USB Adapter is not  
connecting to my access point. What should I do?  
A2: First, verify that the Network Name (SSID) matches your wireless router or access point’s Network  
Name (SSID).Second, check your TCP/IP properties to ensure that Obtain an IP address automatically is  
selected. Third, open the Wireless LAN Configuration Utility icon, click the Site Survey link and then click  
Refresh to check and see if there are any available wireless networks listed.  
Q3: Windows is unable to recognize my hardware. What should I do?  
A3: First, make sure your computer meets the minimum requirements as specified in Section 1 of this  
quick installation guide. Second, you must complete the installation of the wireless configuration utility (as  
described in Section 2) before connecting the Wireless USB Adapter to your computer. Third, connect the  
Wireless USB Adapter to a different USB port of your computer.  
Q4: I cannot open the wireless configuration utility. What should I do?  
A4: First, access your device manager to make sure the adapter is installed properly. If you see a  
networking device with a yellow question mark or exclamation point, you will need to reinstall the device  
and/or the drivers. To access your device manager, right-click My Computer, click Properties, under the  
Hardware tab click Device Manager. Second, if you are running Windows XP, you need to disable  
wireless zero configuration. Go to Control Panel -> Network Connections. Right click on the Wireless  
Network Connection icon and select Properties. Click on the Wireless Networks tab and uncheck Use  
windows to configure my wireless settings. Then click OK.  
Q5: How do I install the drivers on Windows 98SE or ME?  
A5: Please refer to the User's Guide included on the Driver CD-ROM.  
If you still encounter problems or have any questions regarding the TEW-424UB, please refer to the User's Guide  
included on the Utility & Driver CD-ROM or contact Trendnet's Technical Support Department.  
7
 
Certifications  
This equipment has been tested and found to comply with FCC and CE Rules.  
Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference.  
(2) This device must accept any interference received. Including interference that may cause undesired  
operation.  
Este equipamento opera em caráter secundário, isto é, não tem  
direito a proteção contra interferência prejudicial, mesmo de estações  
do mesmo tipo, e não pode causar interferência a sistemas operando  
em caráter primário.  
Waste electrical and electronic products must not  
be disposed of with household waste. Please  
recycle where facilities exist. Check with you Local  
Authority or Retailer for recycling advice.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE  
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS  
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.  
ADVERTENCIA  
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de  
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al  
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador  
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria  
existente en el pais o zona de instalación.  
 
TRENDnet Technical Support  
.
US Canada  
Toll Free Telephone: 1(866) 845-3673  
24/7 Tech Support  
.
.
.
.
.
Europe (Germany France Italy Spain Switzerland UK)  
Toll Free Telephone: +00800 60 76 76 67  
English/Espanol - 24/7  
Francais/Deutsch - 11am-8pm, Monday - Friday MET  
Worldwide  
Telephone: +(31) (0) 20 504 05 35  
English/Espanol - 24/7  
Francais/Deutsch - 11am-8pm, Monday - Friday MET  
Product Warranty Registration  
Please take a moment to register your product online.  
20675 Manhattan Place  
Torrance, CA 90501  
USA  
 
Copyright ©2007. All Rights Reserved. TRENDnet.  

Teac Stereo System MC DX20 User Manual
Tiger Games 36283 User Manual
Timex Watch W 90 User Manual
Toshiba Cordless Telephone SX 2981 User Manual
Tripp Lite Surge Protector ISOBAR12ULTRA User Manual
Univex Indoor Furnishings YB9290 User Manual
Verizon Network Card VZ4000 User Manual
Viking Food Warmer DSCD130 4B User Manual
Vulcan Hart Fryer MGF24 User Manual
Wagner SprayTech Paint Sprayer 294083 User Manual