Toastmaster Automobile Accessories PRO OE3B3 User Manual

TRANSMITTERPROGRAMMINGGUIDE  
Model:PRO-OE3B3  
The transmitters included with the security system have been pre-programmed  
at the factory, with each button pre-assigned to control a specific function of the  
security system. Although the security system in the vehicle has either a 3 or 4  
channel receiver, depending on the model, the transmitters included with the  
system are capable of transmitting 7 distinct signals. This allows you to program  
each transmitter to more than one vehicle in two car families and also allows you  
to change which button(s) control certain functions of the system.  
(Example: Transmitter channel 5 can be programmed to activate Receiver  
channel 2.) Refer to the chart below for access to each of the transmitter channels,  
and for the standard factory button assignments.  
TRANSMITTER  
SYSTEM RECEIVER  
CHANNEL BUTTON  
CHANNEL  
FUNCTION  
Remote Arm  
1
1
Remote Emergency Panic  
Remote Door Lock  
Remote Disarm  
2
3
2
3
4
Remote Emergency Panic  
Remote Door Unlock/Unlock 2  
Single Push Pulsed Output for Optional Accessory  
Or Double Push For Additional Optional Accessory  
Single Push Pulsed Output for Optional Accessory  
Or Push And Hold For Extended Output  
4
5
&
&
Single Push Pulsed Output for Optional Accessory  
Or Push And Hold For Extended Output  
5
6
7
&
6
7
RF Channel For Options  
RF Channel For Options  
All 3  
Buttons  
Some of the more common accessories for these additional channels are;  
AS 9554  
AS 9075  
AS 9153  
AS 9256  
Remote Garage Door Interface  
Remote car starter  
Remote window roll up  
Remote trunk release relay  
128-6121  
1 of 4  
Released 7-17-01.  
 
14. Press and release the valet push-button switch once.  
15. The dash LED will flash four times and the sounding device will beep four  
times,indicatingthesystemisreadytoacceptprogrammingforreceiver's  
channel 4.  
16. Press and hold any button combination as shown on the front cover of  
thisguideuntilthesoundingdeviceemitsalongbeep,indicatingthesignal  
has been stored into memory.  
17. If you have additional transmitters (up to 4) that need to be programmed,  
repeat step 16 for each transmitter.  
18. Press and release the valet push-button switch once.  
19. The dash LED will flash four times, and the sounding device will beep  
four times, indicating the system is ready to accept programming for  
receiver's channel 5.  
20. Press and hold any unused button combination as shown on the front  
cover of this guide until the sounding device emits a long beep, indicating  
the signal has been stored into memory.  
21. If you have additional transmitters (up to 4) that need to be programmed,  
repeat step 20 for each transmitter.  
22. Turn the ignition key off. The sounding device will emit one short beep  
followed by one long beep indicating the system has terminated the  
program mode.  
TRANSMITTERBATTERYREPLACEMENT  
You will notice a decrease in transmitter range as the battery condition  
deteriorates. Transmitter battery replacement is recommended at least  
every 10 to 12 months, depending upon how frequently the transmitter is  
used.  
ThetransmitterhasasmallLEDvisiblethroughthecase.ThisLEDcanbeused  
to indicate battery condition. If the LED does not illuminate, then the battery  
is discharged, and must be replaced.  
To replace the transmitter battery:  
1. Remove the small phillips head screws  
from the bottom cover of the transmitter.  
2. Carefully unsnap the top cover of the  
transmitter from the bottom cover.  
3. Remove the discharged battery, making  
note of the location of the + and - contacts, and replace with a new type  
GP 27A 12 volt battery.  
4. Replace the transmitter cover, taking care not to damage the LED or  
switches on the circuit board, and secure with the small phillips head  
screw.  
128-6121  
3 of 4  
 
ORDER FORM FOR 3 BUTTON TRANSMITTER  
MODEL NO. PRO-OE3B3  
IMPORTANT : To help us expedite your order, please print all of the information legibly,  
and mail this form and your payment according to the instructions below.  
Note: Order Pad # 70 if your Lock & Unlock Icons are White  
Order Pad # 71 if your Lock & Unlock Icons are Red.  
Note: Transmitter model number found on back of case. ___________  
1. Name : ____________________________________________________  
Address: _____________________________________________________  
City : _____________________ State : _______ Zip Code : ____________  
2. Telephone Number : ( _______ ) _________________________________  
3. Enter the total number of transmitters required here : ________________  
4. List model number of your actual transmitter pad as shown on page 4 of this  
manual: _________________________  
5. The cost per transmitter is $ 65.00.  
6. Enter the total amount enclosed here : ____________________________  
(New York state residents must include the appropriate sales tax.)  
7. Method of payment; check one of the boxes below.  
! Mastercard ! Visa ! Check or money order * ( do not send cash )  
* Make checks payable to Audiovox Corporation  
8. Credit Card Number : ________________________________________  
9. Credit Card Expiration Date : _____________________  
Credit card purchasers can order additional or replacement  
transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow  
"
the instructions from the operator interface.  
10. Mail this form, and your check, to ;  
Audiovox Electronics Corp., 150 Marcus Blvd. Hauppauge, N.Y., 11788  
Attn.: TRANSMITTER DEPARTMENT  
© 2001 Audiovox Electronics Corporation, Hauppauge N.Y. 11788  
128-6121  
128-6121  
4 of 4  
 

Teac MP3 Player WAP 4500 User Manual
Telex Stereo Amplifier ACM1202P User Manual
Texas Instruments Calculator TLV320AIC12KEVMB K User Manual
TiVo DVR SDOC 00091 002 User Manual
Toshiba Security Camera IKWR05A User Manual
TP Link Computer Hardware TL WNB51N User Manual
Transcend Information MP3 Player MP860 User Manual
Triarch Indoor Furnishings 75365 10 User Manual
Universal Remote Control Universal Remote Universl Remote User Manual
Vermont Casting Indoor Fireplace DEF33 User Manual