Transition Networks Network Card E 100BTX SX 01 User Manual

MEDIA CONVERTER TECHNICAL SPECIFICATIONS  
Standards  
100BASE-SX, IEEE 802.3u  
Minneapolis, MN 55344 USA  
Delay  
400ns round trip  
Case dimensions  
Shipping Weight  
Environment  
4.7" x 3.0" x 1.0"  
(119mm x 76mm x 25mm)  
100BASE-TX/100BASE-SX Media Converters  
850 Nanometer  
3 lbs  
(0.9 kg)  
Temperature:  
Humidity  
Altitude  
0-40°C (32° to 100° F )  
10-90%, non condensing  
0-10,000 feet  
E-100BTX-SX-01, E-100BTX-SX-01(SC)  
USER’S GUIDE  
The TRANSITION Networks Ethernet™ E-100BTX-SX-01 series 100BASE-TX to  
100BASE-SX media converters connect 100BASE-TX unshielded twisted pair  
cable to 850 nm 100BASE-SX multimode fiber-optic cable, using either an  
ST connector (E-100BTX-SX-01) or an SC connector (E-100BTX-SX-01(SC)).  
Maximum number  
media converters in series:  
2
Warranty  
Lifetime  
Power Supply Requirements Replace power supply with only the equivalent  
input rating (see below) and output rating (regulated 9VDC at 0.5 A).  
A four-positiion switch on the media converter allows selection of Auto-  
negotiation, half-duplex or full-duplex, and/or Link Pass Through (LPT)  
/Remote Fault Detection (RFD). An MDI/MDI-X switch allows straight-  
through twisted-pair cable to be used for crossover 100BASE-TX connections.  
TN PN  
3525  
3525  
3518  
3514  
3525  
Requirement  
Location  
United Kingdom  
Europe  
USA/Canada/Mexico  
Japan  
Australia  
240 volts, 50 hertz  
230 volts, 50 hertz  
120 volts, 60 hertz  
100 volts, 50-60 hertz  
240 volts, 50 hertz  
M D I - X  
M D I  
1
2
3
4
S w i t c h e s  
C o n f i g  
E-100BTX-SX-01  
UTP  
NOTE: This product also can be powered by the Transition Networks E-MCR series media  
converter rack.  
Provides an RJ-45 twisted pair 100BASE-TX  
connector and a set of RX (receive) and TX  
(transmit) ST 100BASE-SX connectors to  
850 nm multimode fiber-optic cable.  
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE  
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in  
damage to the public telephone network.  
Multimode Fiber  
E-100BTX-SX-04  
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten  
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur  
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen  
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.  
M D I - X  
M D I  
1
2
3
4
S w i t c h e s  
C o n f i g  
E-100BTX-SX-01(SC)  
UTP  
Provides an RJ-45 twisted pair 100BASE-TX  
connector and an RX (receive) and TX  
(transmit) SC 100BASE-SX connector to  
850 nm multimode fiber-optic cable.  
Compliance Information  
UL Listed  
C-UL Listed (Canada)  
CISPR/EN55022 Class A  
Multimode Fiber  
E-100BTX-SX-04(SC)  
FCC Regulations  
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant  
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful  
interference when the equipment is operated in a commercial environment. This equipment generates,  
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the  
instruction manual, may cause harmful interference to radio communications. Operation of this  
equipment in a residential area is likely to cause harmful interference, in which case the user will be  
required to correct the interference at the user’s own expense.  
Status LEDs on the connector side of the media converters indicate:  
Power Illuminated green LED indicates  
RJ-45 Connector  
Power  
TX  
RX  
connection to external AC power.  
SDF  
SDC  
RXC  
RXF  
SDF  
SDC  
RXC  
RXF  
Signal Detect/Fiber: Steady green LED  
indicates fiber port is connected to device.  
Signal Detect/Copper: Steady green LED  
indicates RJ-45 port is connected to device.  
Receive/Copper: Flashing green LED  
indicates packets are seen on RJ-45 port.  
Receive/Fiber: Flashing green LED indicates  
UTP/ST
Fiber  
Power  
SC Connectors  
Canadian Regulations  
SDF  
SDC  
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on  
the radio interference regulations of the Canadian Department of Communications.  
Copyright Restrictions  
© 1998, 2001 TRANSITION Networks.  
All rights reserved. No part of this work may be reproduced or used in any form or by any means –  
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.  
RXC  
RXF  
RJ-45 Con
Power  
RX  
TX  
SDF  
SDC  
RXC  
RXF  
UTP/STP  
Fiber  
ST Connectors  
packets are seen on fiber port.  
 
Trademark Notice  
All registered trademarks and trademarks are the property of their respective owners. 33064.C  

Teledyne Pet Fence M201E User Manual
Toastmaster Blender RRBL3A User Manual
Tricity Bendix Cooktop SIE 505 SSE BZ User Manual
Tricity Bendix Oven BS680 1 User Manual
Troy Bilt Lawn Mower 769 10459 User Manual
Turbo Air Refrigerator TGF 13F User Manual
Tyan Computer Computer Hardware Trinity 371 Motherboard User Manual
Tyco Electronics Computer Monitor ET1528L User Manual
Vestax Musical Instrument PMC 05ProIII User Manual
VocoPro Laser Pointer UHF 3200 User Manual