User’s Guide
SSDTF10xx-10x
Stand-Alone Devices
• T1 / E1 with Remote Management
• Copper to Fiber
Transition Networks SSDTF10xx-10x series
Devices encode and decode T1 or E1 twisted-pair
copper signals over fiber optic cable to extend the
distance and transmission reliability of high-speed
T1 or E1 data traffic. The device is framing independent (as ESF vs. D4) and supports all
common line codes (e.g., AMI, B8ZS, HDB3).
The SSDTF10xx-10x is designed to be installed in pairs. For example, install one
SSDTF1011-105 as the “local ” Device and another SSDTF1011-105 as the “remote ”
Device.
Part Number
Port One - Copper
Port Two - Duplex Fiber-Optic
SSDTF1011-105
RJ-45
1.5 km (5,000 feet)*
ST, 850 nm multimode
2 km (1.2 miles)*
SSDTF1012-105
SSDTF1013-105
SSDTF1014-105
SSDTF1015-105
SSDTF1016-105
SSDTF1017-105
SSDTF1018-105
SSDTF1022-105
RJ-45
ST, 1310 nm single mode
1.5 km (5,000 feet)*
8 km (4.8 miles)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
RJ-45
1.5 km (5,000 feet)*
SC, 850 nm multimode
2 km (1.2 miles)*
SC, 1310 nm single mode
20 km (12.4 miles)*
SC, 1310 nm single mode
40 km (24.8 miles)*
SC, 1310 nm single mode
60 km (37.3 miles)*
SC, 1550 nm single mode
80 km (49.7 miles)*
MT-RJ, 1300 nm multimode
2 km (1.2 miles)*
ST, 1310 nm single mode
15 km (9.3 miles)*
SSDTF1025-105
RJ-45
1.5 km (5,000 feet)*
MT-RJ, 1310 nm single mode
20 km (12.4 miles)*
SSDTF1027-105 RJ-45
1.5 km (5,000 feet)*
ST, 1300 nm multimode
5 km (3.1 miles)*
* Typical maximum cable distance. (Actual
distance is dependent upon the physical
characteristics of the network.)
Note: The SSDTF10xx-10x requires a CSU
between the device and the Public Telephone
Network.
Installation .& |