Tripp Lite TV Mount DWF2647X User Manual

Owner’s Manual  
Fixed Flat Screen  
Wall Mount  
MODEL: DWF2647X  
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR  
PROPERTY DAMAGE MAY OCCUR!  
200x200/300X300  
400X200/400x400  
55”  
75kg  
MAX  
(165lbs)  
MAX  
Русскоязычная версия настоящего руководства представлена на веб-сайте компании  
Copyright © 2013 Tripp Lite. All rights reserved.  
 
13-09-233-93329F.indd  
1
10/31/2013 11:59:41 AM  
Component Checklist  
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to  
(x1)  
(x1)  
(x1)  
(x2)  
M5X10 (x4)  
(x1)  
Package M  
M5X14 (x4)  
M6X14 (x4)  
M8X20 (x4)  
M6X30 (x4)  
M8X30 (x4)  
Washer (x4)  
Small Spacer (x8)  
Big Spacer (x4)  
Package W  
Anchor Bolt (x4)  
Concrete Anchor (x4)  
D6 Washer (x4)  
3
 
13-09-233-93329F.indd  
3
10/31/2013 11:59:41 AM  
1. Assemble the Wall Plate  
M5X10  
2a. Mount on Wood Stud Wall  
1
Find and mark the  
exact location of  
mounting holes  
2
3
D6 Washer  
Drill pilot holes  
Anchor Bolt  
Screw the wall  
plate onto the  
wall  
WARNING  
• Make sure that mounting screws are anchored into the center of the studs.  
Use of a stud finder is highly recommended.  
• Installers are responsible to provide hardware for other types of mounting situations.  
• Installers must verify that the supporting surface will safely support the combined  
load of the equipment and all attached hardware and components.  
4
 
13-09-233-93329F.indd  
4
10/31/2013 11:59:41 AM  
2b. Mount on Solid Brick and Concrete Block  
1
Mark the  
exact location of  
mounting holes  
2
Drill pilot holes  
D6 Washer  
Concrete Anchor  
Anchor Bolt  
Screw the wall  
plate onto the  
wall  
WARNING  
• When installing wall mounts on cinder block, verify the actual concrete thickness  
is at least 1-3/8” (35mm) for using the concrete anchors. Do not drill into mortar  
joints! Be sure to mount in a solid part of the block, generally 1” (25mm) minimum  
from the side of the block. It is suggested an electric drill on a slow setting be used  
to drill the hole instead of a hammer drill to avoid breaking out the back of the hole  
when entering a void or cavity.  
• Installers must verify that the supporting surface will safely support the combined  
load of the equipment and all attached hardware and components.  
5
 
13-09-233-93329F.indd  
5
10/31/2013 11:59:42 AM  
3. Install Adapter Brackets  
3-1 For Flat Back Screen  
M5X14  
M6X14  
M8X20  
TV  
TV  
TV  
Washer  
Note: Choose appropriate screws, washers and spacers (if  
necessary) according to the type of screen.  
• Position the adapter brackets as close as possible to the  
center of the display.  
• Screw the adapter brackets onto the display.  
Tighten all screws but do not over tighten.  
3-2 For Recessed Back Screen or to Access A/V Inputs  
TV  
TV  
TV  
M8X20  
Washer  
Small Spacer  
M8X20  
M6X30  
M8X30  
or  
M6X30  
M8X30  
M6X30  
M8X30  
Washer  
Washer  
Washer  
or  
or  
Small Spacer  
Big Spacer  
Small Spacer  
Small Spacer  
Big Spacer  
6
 
13-09-233-93329F.indd  
6
10/31/2013 11:59:43 AM  
4. Hang Display onto the Wall Plate  
Wall  
Wall  
Safety Clamp  
• Hook the display over the top of the wall plate.  
• Push the safety clamps upward and tighten the two screws to lock the bracket.  
Maintenance  
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).  
7
 
13-09-233-93329F.indd  
7
10/31/2013 11:59:43 AM  
13-09-233 • 93-329F_revA  
8
 
13-09-233-93329F.indd  
8
10/31/2013 11:59:44 AM  

THORENS Stereo Amplifier TEM 3200 User Manual
True Manufacturing Company Refrigerator TGU 2 User Manual
Ultra Products Ventilation Hood ULT33186 User Manual
Verizon TV Receiver FiOS TV User Manual
Vivitar Binoculars VIV AV 842 User Manual
Vivitar Digital Camera X327 User Manual
Vivotek Network Router ND4801 User Manual
Volkswagen GPS Receiver 4NSF User Manual
Watlow Electric Switch Series D8 User Manual
Weber Charcoal Grill 41093 User Manual