DCM 300
Intelligent 2 Door Controller
FEATURES
• Support for two doors
OVERVIEW
• On-board 10/100 Mbps Ethernet
The DCM 300 (Door Control Module) is a low cost, two-door controller designed to
interface third-party read heads with the CEM range of access control systems.
• Communicates directly with the
central system
The DCM 300 has an on-board 10/100 Ethernet connection and communicates directly
with the AC2000 central system. Using a powerful 32bit processor, the DCM 300 gives
full off-line validation and decision making capability at the point of entry, when host
communication is not available.
• Structured database allows storage
of large amounts of cardholder
records for off-line card validation
• Reader communications via
standard Wiegand or Mag Stripe
interfaces
The DCM 300 supports most third-party access control read heads conforming to the
physical Wiegand/Mag Stripe (data/data, clock/data) interfaces, covering a range of
technologies from RF Proximity to Biometric devices.
• Eight supervised inputs (four
available per door)
The DCM 300 supports two door configurations. It can either be configured for two read
heads on two separate doors, with optional Exit push buttons, or can be configured to
support two reader heads (an Entry/Exit configuration) for bi-directional control on a
single door.
• Two relays (normally opened or
closed) and open collector outputs
• Self resetting fuses – saves
maintenance time
• Onboard LED - provides visual
status
• Dedicated tamper input
• Suitable for use with AC2000
family:
AC2000 Lite
AC2000 SE
AC2000 AE systems
DCM 300
|