VTech Telephone I6720 User Manual

Connect power to handset charger  
Choose the location for your handset charger, and plug charger adapter into an  
electrical outlet not controlled by a wall switch.  
Register a handset  
When the handset shows NOT REGISTERED, place  
the handset on a base unit or charger that is connected  
to a power outlet. The handset screen will display  
PRESS FIND HNDST 4 SEC ON BASE.  
Press and hold FIND HANDSET on the base unit  
until the IN USE light comes on. (It takes at least four  
seconds).  
NOT RIGISTERD  
Quick installation guide  
i6720  
Parts checklist:  
Check to make sure the phone’s package includes the following:  
1. AC power adapter  
2. Charger  
PRESS FIND HNDST  
4 SEC ON BASE  
elease FIND HANDSET once the IN USE light comes  
on.  
3. Handset  
NOTE:  
4. Battery compartment cover  
5. Belt clip  
If PRESS FIND HNDST 4 SEC ON BASE does not appear on the screen after  
a few seconds, lift up handset and place in base unit or charger again.  
6. Battery  
7. Quick installation guide  
On the i6725 base:  
Charge the handset battery  
Place the handset in the base unit. CHARGING... will display on handset. Be  
sure to charge the battery for at least 16 hours before using your telephone.  
NOTE:  
eturn the handset to the base unit when not in use to ensure optimum  
performance.  
1. AC power adapter  
3. Handset  
2. Charger  
On the i6765/75/85/86 base:  
Belt clip  
Align the pins on the inside edge of the clip with the notches on the sides of the  
handset.  
4. Battery compartment  
cover  
7. Quick installation  
guide  
5. Belt clip  
6. Battery  
NOTE:  
com or call VTech Communications, Inc. at 1 (800) 595-9511. In Canada, go  
1 (800) 267-7377.  
To attach  
To remove  
After a while the handset will emit series of tones, the newly registered handset  
will be assigned the lowest extension number not previously assigned to another  
system handset when successfully registered. epeat the steps in Register  
a handset if the new handset does not successfully register to the base unit  
within two minutes.  
Install handset battery  
1. Align the two holes in the plug with the socketpins, matching the red and the  
black connectors, then snap plug into place.  
2. Place the battery in the compartment with the wires in the upper right  
corner.  
3. Neatly tuck the wires next to the battery inside the battery compartment.  
Registration  
Tꢁ ꢈꢃꢊꢋꢉꢂꢃꢈ ꢂꢌꢃ ꢋ6720 ꢌꢍꢎꢏꢉꢃꢂ ꢂꢁ ꢅꢁuꢈ ꢁꢈꢋꢊꢋꢎꢍꢐ ꢉꢅꢉꢂꢃꢑ, ꢅꢁu ꢌꢍvꢃ ꢂꢁ ꢆꢈꢉꢂ ꢏꢃ-ꢈꢃꢊ-  
ister all your handsets, then register the new handset and re-register all the old  
handsets one at a time.  
De-register all handsets  
Note:  
Press and hold FIND HANDSET on the base unit for four seconds, the IN  
USE light will light up.  
Keep pressing FIND HANDSET for another six seconds until the IN USE  
ꢐꢋꢊꢌꢂ ꢉꢂꢍꢈꢂꢉ ꢂꢁ flꢍꢉꢌ, then release the FIND HANDSET button.  
Press and release FIND HANDSET again. The IN USE light will turn off and  
in a few seconds, all handsets will be de-registered.  
If the de-register process does not work, you may need to reset the system  
4. eplace cover by sliding it upwards until it clicks into place.  
and try again. To reset: pick up the handset and press TALK/  
/FLASH.  
Then, press the OFF button and place the handset back into the base unit.  
Wꢌꢃꢎ ꢆꢈꢉꢂ uꢈcꢌꢍꢉꢃꢏ ꢅꢁu ꢎꢃꢃꢏ ꢂꢁ cꢌꢍꢈꢊꢃ ꢅꢁuꢈ ꢌꢍꢎꢏꢉꢃꢂꢉ ꢄꢁꢈ ꢆvꢃ ꢑꢋꢎuꢂꢃꢉ  
before registering to base unit.  
On the i6725 base:  
Important:  
If this product is not working properly:  
2. Call our customer service at 1-800-595-9511 or 1-800-267-7377 in Canada.  
On the i6765/75/85/86 base:  
NOTE:  
Use only the VTech battery and AC power adapter supplied with this unit or the  
recommended equivalent.  
If you are not going to use the telephone for a long period of time, remove the  
battery to prevent possible leakage.  
�o not open or mutilate the battery. eleased electrolyte is corrosive and may  
cause damage to the eyes or skin. It may be toxic if swallowed.  
Exercise care in handling batteries in order not to create a short circuit with  
conducting materials such as rings, bracelets, and keys. The battery or  
conductor may overheat and cause burns.  
�ꢁ ꢎꢁꢂ ꢏꢋꢉꢁꢉꢃ ꢁꢄ ꢂꢌꢃ ꢍꢂꢂꢃꢈꢅ ꢋꢎ ꢍ ꢆꢈꢃꢇ ꢋꢂ ꢑꢋꢊꢌꢂ ꢃꢐꢁꢏꢃ  
 

Thule Automobile Accessories 017 User Manual
Tiger Products Co Ltd Can Opener JHC 72UA User Manual
Timex Clock Radio T301 User Manual
Top Innovations Vacuum Cleaner MC1910 User Manual
Toro Utility Trailer 3040 User Manual
Triarch Indoor Furnishings 60169 User Manual
Trimline Waterskis t523 User Manual
Tripp Lite Switch OmniSmart USB User Manual
Troy Bilt Lawn Mower TB310QS User Manual
True Fitness Exercise Bike LC900 User Manual