Verilux Network Router 41TDM User Manual

45-00129  
4.0  
41TDM  
Configuration Guide  
®
115VAC  
50/60Hz  
116ma  
T
R
A
N
S
P
O
R
T
PORT  
A
PORT  
B
LAN  
SLIP  
SUPV  
DBU  
DDS  
EXIT  
SCROLL SELECT  
TDM  
TEST ALARM POWER  
PRISM 41TDM  
Reporting:  
Front panel LEDs, call out  
on alarm (COA), SNMP  
TRAPs  
Specifications  
Network Interface  
DDS-II Port Data Rates  
Standard mode  
Service Type:  
DDS-I or DDS-II clear  
channel  
Port A:  
Port B:  
Sync only at 64 kbps  
Inactive  
Power  
115 VAC:  
116 mA, 8 W max,  
27 BTU max  
Operating Modes: Full duplex, point-to-point,  
multi-point  
Proprietary, non-TDM mode  
Mechanical  
Housing:  
Line Rate:  
56 and 72 kbps  
Port A:  
Sync at 2.4, 4.8, 9.6, 19.2,  
38.4, 56, 60 kbps  
Plastic standalone case  
Loop Range:  
Up to 45 dB of loss  
Mounting:  
Dimensions:  
Desktop or horizontal rack  
Async: at 2.4, 4.8, 9.6,  
19.2, 38.4, 56, 57.6 kbps  
Line Connection: RJ-48C jack, 8-pin  
modular  
12 inches (30.40 cm) wide  
2 inches (5.08 cm) high  
9 inches (22.86 cm) deep  
Port B:  
Inactive  
Timing Source:  
DDS-I: Network, Internal  
DDS-II: Network  
Proprietary, TDM mode  
Weight:  
4 pounds (1.814 kg)  
Antistream Timer: Off, 10, 30, or 60 seconds  
Port A:  
Sync at 2.4, 4.8, 9.6, 19.2,  
Environmental  
*
Supervisory Port  
or 38.4 kbps  
Storage Temp:  
32° to 122°F (0° to 50°C)  
Connection:  
Data Rates:  
8-pin modular (RS-232)  
1.2, 2.4, 9.6, and 19.2 kbps  
Async at 2.4, 4.8, 9.6,  
*
Operating Temp: 4° to 185°F (20° to 85°C)  
19.2, or 38.4 kbps  
Humidity:  
95% maximum (non-  
condensing)  
Port B:  
Sync at 2.4, 4.8, 9.6, 19.2,  
or 38.4 kbps  
SLIP Port  
Connection:  
Data Rates:  
*
8-pin modular (RS-232)  
1.2, 2.4, 9.6, and 19.2 kbps  
Compatibility  
TR 62310:  
Async at 2.4, 4.8, 9.6,  
*
November 1987  
19.2, or 38.4 kbps  
Ethernet (option)  
*Only one port can be set for 38.4 kbps at a  
time. If Port A is set to 38.4 kbps, Port B is lim-  
ited to 19.2 kbps. If Port B is set it 38.4 kbps,  
Port A is limited to 19.2 kbps.  
TR 62310A:  
December 1989  
(addendum 3)  
Connection:  
8-pin modular  
Network Protocol: TCP/IP-based networks  
TR 41450:  
November 1981  
Data Rate:  
10 Mbps  
Internet Standards: RFC 1157 (SNMP)  
RFC 1155 (SMI)  
Compatibility:  
10BASE-T, ISO/IEC  
8802-3  
RFC 1213 (MIB-II)  
RFC 1055 (SLIP)  
Enterprise TXPORT MIB  
Enterprise DDS MIB  
Connections  
SUPV/SLIP and DDS Pinout  
Token Ring (option)  
Pin SUPV/SLIP  
DDS  
Connection:  
8-pin modular (RJ-45)  
1
2
3
4
5
6
7
8
DTR Out  
RTS Out  
Frame Gnd  
Data Out  
Data In  
Data Out (Tip)  
Network Protocol: TCP/IP based networks  
DDS-I Port Data Rates  
Standard mode  
Data Out (Ring)  
Data Rate:  
4 or 16 Mbps  
Compatibility:  
Type 3 UTP, ISO/IEC  
8802-5  
Port A:  
Port B:  
Sync onlyat 56 kbps  
Inactive  
Dial Backup  
Signal Gnd  
CTS In  
Proprietary, non-TDM mode  
Connection:  
6-pin modular  
Data In (Tip)  
Port A:  
Sync at 2.4, 4.8, 9.6, 19.2,  
DCD In  
Data In (Ring)  
Backup Service: ISDN, sync  
38.4, or 52 kbps  
Configuration:  
Information for backup  
Port A and Port B Pinouts  
Async at 2.4, 4.8, 9.6,  
19.2, 38.4, or 57.6 kbps  
unit is stored in unit and  
transmitted to backup unit  
by inband AT commands.  
ITU Ckt Name  
V.35 RS-232 EIA-530 DCE  
101/AA Frm Gnd  
102/AB Sgnl Gnd  
103/BA TxD  
104/BB RxD  
105/CA RTS  
106/CB CTS  
107/CC DSR  
108/CD DTR  
109/CF DCD  
114/DB TC  
A
1
1
Gnd  
Gnd  
In  
Port B:  
Inactive  
B
7
7
Dialing:  
Numbers programmed and  
stored in unit and  
Proprietary, TDM mode  
P, S  
R, T  
C
2
2, 14  
3, 16  
4, 19  
5, 13  
6, 22  
20, 23  
8, 10  
12, 15  
9, 17  
18  
Port A:  
Sync at 2.4, 4.8, 9.6, 19.2,  
or 31.2 kbps  
3
Out  
In  
transmitted to backup unit  
by inband AT commands.  
*
4
Async at 2.4, 4.8, 9.6,  
D
5
Out  
Out  
In  
Restoral:  
Manual or automatic restoral  
to leased line service  
*
19.2, or 31.2 kbps  
E
6
H
20  
8
Port B:  
Sync at 2.4, 4.8, 9.6, 19.2,  
or 31.2 kbps  
Diagnostics  
*
F
Out  
Out  
Out  
In  
Loopbacks:  
V.54 (send and receive),  
alternating loop (DDS-I),  
latching loop (DDS-II)  
Y, AA 15  
V, X 17  
18  
Async at 2.4, 4.8, 9.6,  
*
115/DD RC  
19.2, or 31.2 kbps  
141/LLB LL  
*Only one port can be set for 31.2 kbps at a  
time. If Port A is set to 31.2 kbps, Port B is lim-  
ited to 19.2 kbps. If Port B is set it 31.2 kbps,  
Port A is limited to 19.2 kbps.  
BERT:  
511 pattern  
140/RLB RL  
21  
21  
In  
142/TM Test Mode  
25  
Out  
Alarms  
Activation:  
Programmable thresholds  
 

Teledyne Respiratory Product MX300 I User Manual
Toastmaster Popcorn Poppers TPC2 User Manual
Topcom Network Router 881 PSTN User Manual
Toshiba Scanner GA 1201 User Manual
Tricity Bendix Oven BD 912 User Manual
Tyco Electronics Computer Monitor 1938L User Manual
Tyco Electronics Computer Monitor B1ET 1215L User Manual
Ultratec Printer PRO80 User Manual
Uniden Bluetooth Headset BT230 User Manual
Vermont Casting Indoor Fireplace WinterWarm Fireplace Insert or System User Manual