Vizio Vacuum Cleaner VS 03R User Manual

VAXCARE  
Vaxcare:  
AUST: 1300 36 4040  
NZ: 0800 800 900  
Please register your warranty. Send in your completed Warranty Card.  
If you require any further assistance or advice about any  
VAX please call VAXCARE on  
1300 36 4040  
(Australia - cost of a local call)  
(NZ)  
and  
0800 800 900  
2000 WATT  
VAX Appliances (Australia) Pty Ltd  
A.C.N. 009099736  
296 Victoria Road Malaga Western Australia 6090.  
AUST. & NZ BRANCHES  
• NSW/ACT  
• QUEENSLAND  
Unit 2, 239 Beaconsfield St,  
186 Kerry Road,  
Milperra, NSW 2214  
Telephone: (02) 9792 8900  
Facsimile: (02) 9792 8911  
Archerfield, QLD 4108  
Telephone: (07) 3216 7350  
Facsimile: (07) 3216 7375  
• VICTORIA/TASMANIA  
Unit 3, 46 Burgess Road,  
Bayswater North, VIC 3153  
Telephone: (03) 9761 7160  
Facsimile: (03) 9761 7175  
• WESTERN AUSTRALIA  
296 Victoria Road,  
Malaga, WA 6090  
Telephone: (08) 9247 8100  
Facsimile: (08) 9247 8192  
Please read carefully before using your VS-03R.  
Always fully extend mains cable before use.  
• SOUTH AUSTRALIA/  
NORTHERN TERRITORY  
Unit 3, 75-77 Grange Road,  
Welland, SA 5007  
Telephone: (08) 8340 2222  
Facsimile: (08) 8346 7933  
• VAX APPLIANCES  
NEW ZEALAND  
27 Clemow Drive  
Mt Wellington, Auckland  
Telephone: (09) 5736220  
Facsimile: (09) 5736224  
Download from Www.Somanuals.com. All MaInunalssStearrcuh AcndtDioownnloadM. anual  
Motor Thermostat  
Looking After Your Vax  
IMPORTANT: The motor is equipped with a  
thermal cut-out. If for any reason, the vacuum  
cleaner should over-heat, the thermostat will  
automatically turn the unit off. Should this  
occur, unplug the vacuum cleaner from the  
electrical outlet and turn the unit off. Remove  
the dirt container and empty. Clean the filters.  
Allow the cleaner to cool for approximately  
one (1) hour. To re-start, plug into an electrical  
outlet and switch back on.  
IMPORTANT: The Vax VS-03R is a very powerful vacuum cleaner. It will collect an extraordinary  
amount of dust and dirt, especially during the first few applications of use, which will quickly  
fill a paper dust bag or block the pores of a cloth dust bag. Excessive dust and dirt will also  
contaminate the motor protection and air outlet filters.  
Any of these conditions usually result in a noticeable drop-off in suction, or a possible motor  
shut down due to thermostat activation.  
On such occasions, it will be necessary to replace the paper dust bag or wash and thoroughly dry  
a cloth dust bag before reusing, and renew all filters to regain peak suction and performance.  
Replacement Bags & Filters  
Replacement bags and filters are available  
from your Vax stockist or Vax direct. Phone  
VAXCARE Service & Help  
AUSTRALIA 1300 36 4040  
NEW ZEALAND 0800 800 900  
Any queries or concerns about using the  
Vax, call VAXCARE.  
Please make a note of the serial number  
and model number of the appliance before  
calling.  
Your appliance is equipped with a dust bag. If you notice that the vacuum cleaner seems to be  
less efficient than usual, check the dust indicator by selecting the maximum power and lifting  
the cleaner tool off the floor. If the indicator turns red, change the bag.  
To change the dustbag  
Turn off the appliance and unplug it. Lift up the catch to gain access to the dustbag compartment  
and raise the cover (fig.13). Pull the handle up to remove the bag holder (fig.13a). The bag can  
then be unclipped and disposed of hygienically (fig.14). Do not forget to regularly change the  
dust bag and filter. The efficiency of your cleaner and the life of the motor depends on it.  
(Aust only: Mon-Fri. 10.00am to 6.00pm. EST)  
Calls are charged at the local rate.  
An answerphone is available out of these  
hours.  
There are over 300 approved Vax Service  
Agents in Australia and New Zealand. For  
the nearest Service Agent, please refer to  
your Vax warranty or call VAXCARE or visit  
Dustbag Indicator  
When the indicator light comes on or when the suction power reduces substantially, this  
indicates that you should change/empty the dust bag.  
Attention: If after inserting a new dust bag, the indicator light stays on, this could be  
for several reasons:  
Technical Specification  
Suction passages may be blocked - check flexible hose and extension tubes, suction  
inlet, floor brushes and nozzles for obstruction.  
Voltage:  
Wattage:  
Capacity:  
Filters:  
220-240V~50Hz  
2000W  
3.5 litres  
Motor protection filter  
Air outlet filter  
Check motor protection filter  
Check to see if air outlet filter is dirty  
Check carefully which of these causes is making the light go on and correct it so that the  
vacuum cleaner can work normally.  
Cord length: 5 metres  
Do not work the vacuum cleaner with this indicator light on, as this could cause  
irreparable damage to the motor.  
Weight:  
Part No:  
10kg  
73000  
Subject to technical change without notice.  
 
6
3
Fig.5 Press the foot pedal to start the vacuum cleaner. To stop it press the pedal again.  
Fig.6 Press the foot pedal to recoil the power lead. NOTE: Guide power cord with one hand.  
Rewind 1-11/2 metres of cord at a time. This will prevent the cord from whipping  
which could cause damage or injury.  
How to Use Your Vax VS-03R  
Fig.7 The hose grip has buttons for control of suction power.  
Assembling the Appliance  
Fig.1 The telescopic extension tubes can be lengthened by pressing the button & sliding the  
inner tube to required length.  
Fig.2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible  
hose into the attachment point on the vacuum cleaner.  
Fig.8 Vacuum power can be adjusted electronically by pressing one of the buttons on the  
handle (fig.7).  
Auto - for normal vacuuming of carpets and hardfloors.  
Min - for curtains - soft furnishings.  
Max - for very dirty carpets or carpet with high pile.  
Using the accessories  
Fig.9 Open the accessory storage compartment (fig. 9a). These accessories can be fitted  
directly to the tubes or onto the end of the flexible hose handle. The small cleaning tool  
is used for upholstered furniture. The crevice nozzle is ideal for cleaning awkward places  
such as behind radiators, skirting boards and hard to reach areas. The brush attachment  
is designed for dusting.  
Adjusting the cleaning tool for carpets & hard floors  
Fig.3 Hard floor position (tiles, parquet floors, etc.) - The cleaning tools brush must be in the  
lower position. Press on the rocker switch to lower it.  
Fig.4 Carpet or rug position - The cleaning tools brush should be raised.  
Press the rocker switch to lift the brush up.  
ON/OFF  
MAX  
MIN  
AUTO  
Fig.10  
If you wish to pause briefly during vacuuming i.e. to move a piece of furniture or  
a rug, use the special parking position on your vacuum cleaner. Slide the hook  
attached to the large cleaning tool into the slot on the rear of the appliance. When  
you have finished vacuuming, press pedal to stop the appliance then unplug it at  
the mains. Press the pedal to automatically rewind the cord (See note fig.6).  
Fig.11 & 12 You can move or store your appliance in a vertical position by sliding the hook on  
extension tube into the clip on the underside of the appliance.  
Getting started  
Fully extend the mains cable but not beyond the yellow marker and plug it into a  
standard domestic outlet  
This practical system allows you to carry the vacuum cleaner around in one hand  
and provides minimum storage space.  
 
4
5

Teac Fryer HD63G Series User Manual
Thomas Betts Furnace EEDU User Manual
Topcom Digital Photo Frame NG8060 User Manual
Toshiba Cash Register MA 230 User Manual
Tricity Bendix Freezer TB 44 UF User Manual
Tricity Bendix Freezer TB 85 F User Manual
Uniflame Charcoal Grill CBC1255SP User Manual
Unitron Hearing Aid Hearing Aid Moxi2 User Manual
Viking Range VGCC548 6G User Manual
Vivotek Security Camera SD7151 User Manual