Tascam MP3 Player DR 680 User Manual

Owner's Manual Addendum  
DR-680  
Connecting a mid-side microphone  
Added functions  
The following functions have been added with  
firmware version 1.20.  
When using this unit's mid-side decoding function,  
connect the mid signal to the odd channel and the  
side signal to the even channel in the pair. If you  
connect them in reverse, correct decoding is not  
possible.  
1 Mid-side (MS) microphone decoding mode  
2 GANG function  
For example, connect the mid signal to channel 3  
and the side signal to channel 4.  
MS microphone decoding  
mode  
Recording with mid-side decoding  
MS MODE  
1
On the  
screen, set the decoding  
Setting the MS decoding mode  
INPUT  
mode to  
.
MS MODE  
SYSTEM  
Select the  
open the  
item on the  
screen.  
menu to  
2
Press the MIX PAN key on the front panel to  
MS MODE  
PAN  
open the  
screen (pan pot adjustment  
screen). Use the MS width control to adjust the  
width of the mid-side signal pair.  
Set the decoding mode to use when connecting mid-  
side microphones. Channel pairs 1-2, 3-4 and 5-6 can  
each be set separately.  
Press one of the number (1-6) keys on the front  
panel that corresponds to one of the mid-  
INPUT  
OFF (default value)  
Recording and playback use the ordinary mode  
(no mid-side decoding).  
side channels that was set to  
on the  
MS MODE  
screen. (For example, press 3 or 4 to  
adjust paired channels 3 and 4.)  
INPUT  
Use this mode to decode while recording.  
Use the VALUE dial to adjust the width of the  
signal suitably in a 0–100 range. At 0, only the  
mid channel is included in the stereo decoding.  
As the value is increased, more of the side  
channel is included in the stereo decoding. At  
100, only the side channel is included. (The  
Playback uses the ordinary mode.  
MONITOR  
Use to monitor the output of mid-side  
microphones with decoding while recording  
without decoding.  
0
default value is .)  
Also use this with a take that was recorded  
without decoding to decode it during playback.  
3
Press the MIX LEVEL key on the front panel  
LEVEL  
to open the  
screen, and adjust the  
A.OUT SEL  
MIX  
In that case,  
the  
should be set to  
in  
decoder output.  
I/O  
menu.  
NOTE  
MS MODE  
The  
screen settings cannot be changed  
during recording or playback. Always stop the unit  
(the transport icon should be ) before changing the  
settings.  
Press one of the number (1-6) keys on the front  
panel that corresponds to one of the mid-  
INPUT  
side channels that was set to  
on the  
MS MODE  
screen. (For example, press 3 or 4 to  
adjust paired channels 3 and 4.)  
D01141120A  
TASCAM DR-680 1  
 

Taurus Group Electric Heater CA 2002 User Manual
Theta Digital DVD Player Compli User Manual
Toastmaster Convection Oven 7093S User Manual
Toshiba DVD Recorder RD XS54SU User Manual
TP Link Network Card TL PA4020P User Manual
Tripp Lite Power Supply 450 RT User Manual
UNICOM Electric Switch SmartGST 2404GM User Manual
Uniden Cordless Telephone DECT1560 User Manual
ViewSonic Flat Panel Television CDE3200 L User Manual
ViewSonic Flat Panel Television VT2230 User Manual