Tripp Lite Switch PAM 2 User Manual

Owner’s Manual  
PAM-2  
1111W.35th Street  
Chicago, IL 60609 USA  
Customer Support: (773) 869-1234  
WiringInstructions  
Connecting a PAM-2 to the Output of a Unison® SU6K or SU10K  
WARNING: Before connection, make sure that your Unison system is OFF, that  
both input and output breakers are switched OFF and that the system is not  
connected to AC power. (See Unison Owner’s Manual.)  
• Strip an additional 1” to 2” of the outer (black) casing of the power cord  
away from the internal colored wires. Neatly shape the exposed metal  
ends of the four colored wires to eliminate loose strands.  
• Slip the strain relief provided over the exposed end of the power cord,  
then thread the exposed end of the power cord through the knockout  
nearest the right of the Unison’s terminal block.  
• Connect the colored wires to the Unison’s terminal block as shown below.  
The black cord can be connected for either 240V output or 208V output.  
Note: the desired output voltage MUST match the Unison’s input voltage.  
(See Unison Owner’s Manual.)  
• Tighten the strain relief and affix it to the knockout.  
Red  
White Green  
Black  
Black  
(240V)  
(208V)  
(Note: This diagram shows the terminal block of a SU6kVA model. SU10kVA  
models have double connectors, but the wires are attached to the same terminals  
on both models.)  
Copyright ©2000 Tripp Lite. All rights reserved. Unison® is a registered trademark of Tripp Lite.  
93-1833 (200004143) 5/00  
 

Thermador Range PGR30 User Manual
Thule MP3 Player TK3 User Manual
Toshiba Personal Computer M30 35 User Manual
Tripp Lite Network Cables F007 006 User Manual
Tyan Computer Personal Computer B4881V50S4H User Manual
Vertical Communications Telephone Scout Telephone User Manual
ViewSonic CRT Television PJD6553W User Manual
Viking Beverage Dispenser DDWB300 User Manual
Vizio SONAR VSB201 User Manual
Vornado Ventilation Hood AVH4 User Manual